How to cooperate to use collector ring and motor

Collector ring has many names, such as conductive ring, slip ring or ring, collecting ring result there are many ways, there are die-casting and slip ring assembly, materials are not the same, there was also of steel copper. First, the original mounted on the motor shaft of the slip ring, the brush device is designed as an independent set of electrical device, via electrical cable tray flange and the motor are mechanically and electrically connected. New slip ring slip ring brush device with double bearing support, electrical slip ring power flange plus cushioning effect, collecting ring jitter can be completely avoided; Meanwhile, the motor shaft is no longer in direct contact, new slip ring collector ring brush device small diameter, which is about half the diameter of conventional slip ring, slip ring speed reduced by 1/2, the corresponding brush wear significantly reduced, life can be increased by 3 - 4 times . Replace the motor,fiber optic rotary joint when installed in place, so that collector ring contact area with the motor shaft assembly to reduce or too loose and cause the vibration will cause problems. Conductive ring before assembly should first check the size selection with the use of basic shaft system. Avoid improper selection tolerances appear too tight or too loose phenomenon. Collector ring operating state without exception jitter, which can solve the fundamental problem of conventional ignition. New collector ring wire-speed low-life, traditional products can be about 6 times. Collector ring in the new overall configuration of the brush contain automatic test features to improve efficiency.